- This topic has 0 replies, 1 voice, and was last updated 3 years, 6 months ago by wqshaider.
December 5, 2019 at 7:37 am #388wqshaiderKeymaster
How to Check Your Car’s Engine Oil
A one-minute investment can keep your car healthy and running smoothly
Think of motor oil as the life’s blood of your car’s engine. Checking it on a regular basis is a key part of keeping your engine running well and getting the most miles out of it. The oil lubricates the engine’s internal moving parts, keeping them from wearing too quickly. It also helps keep the engine clean, by preventing dirt buildup, and helps keep it from overheating.
Checking the oil level is a quick, easy job that we recommend you do at every other gas fill-up. All you’ll need is a rag or paper towel, and your car’s owner’s manual if you have questions.
Engine Oil, Check!
First, check the owner’s manual and follow the automaker’s recommendations. Some newer cars have electronic oil monitors and don’t have traditional dipsticks for manual inspection.
If checking the oil yourself, make sure the car is parked on level ground and, with most cars, the engine is cold, so you don’t burn yourself on a hot engine part. (With some cars, the automaker recommends that the oil be checked after the engine has been warmed up.) With the engine off, open the car’s hood and find the dipstick. Pull the dipstick out from the engine and wipe any oil off from its end. Then insert the dipstick back into its tube and push it all the way back in.
How to check oil level with a dipstick
The dipstick shows the oil is low and needs to be topped off.
Pull it back out, and this time look at both sides of the dipstick to see where the oil is on the end. Every dipstick has some way of indicating the proper oil level, whether it be two pinholes, the letters L and H (low and high), the words MIN and MAX, or simply an area of crosshatching. If the top of the oil “streak” is between the two marks or within the crosshatched area, the level is fine.
But if the oil is below the minimum mark, you need to add oil as described below.
Beaker with dark used oil
Used oil is dark.
Also, check the oil’s color. It should appear brown or black. But if it has a light, milky appearance, this could mean coolant is leaking into the engine. Look closely for any metal particles, too, as this could mean there is internal engine damage. If you see either of these conditions, get the car to a mechanic for further diagnosis. If you suspect a coolant leak, have the car towed.
If everything’s okay, wipe off the dipstick again and insert it back into its tube, making sure it’s fully seated. Close the hood and you’re done.
How to Add Oil
Use the grade of oil recommended in the owner’s manual. It will usually have a designation such as 0W-20 or 5W-30. You can buy it by the quart at any service station or auto-parts store, as well as in many supermarkets and discount retailers.
To add oil, remove the oil filler cap, usually located on top of the engine. Since over-filling with oil is bad for the engine, you should add oil a little at a time. Start by adding about half a quart. Using a funnel helps avoid spills. Wait a minute or so and check the dipstick again. If the level is still below or near the minimum mark, add the rest of the quart. Unless your engine is leaking or burning oil (or if you haven’t checked it in awhile) you will rarely need to add more than a quart. However, if a second quart is needed, add that in slowly as well, checking as you go.
Screw the oil filler cap back on securely, and you’re done.
By Consumer Reports
- You must be logged in to reply to this topic.